ISO 22000 Certification

Last updated

Definition of ISO 22000 Certification

ISO 22000 certification is independent confirmation that an organization's food safety management system meets ISO 22000, the international standard for organizations anywhere in the food chain, including makers of food packaging. The current edition is ISO 22000:2018. It combines the hazard analysis and critical control point (HACCP) principles set out by the Codex Alimentarius Commission, a method for identifying and controlling food safety hazards, with the management system structure used in ISO 9001. The standard also requires prerequisite programs, the basic hygiene and operating conditions a site must maintain. For packaging manufacturers these are set out in ISO/TS 22002-4, which covers points such as pest control, cleaning, personal hygiene and the control of foreign matter. Accredited certification bodies issue the certificate, which is usually valid for three years with annual surveillance audits.

Why ISO 22000 Certification Matters for Your Business

Packaging that touches food is treated as part of the food safety chain, so a contaminated container or a cap that sheds plastic particles becomes a food safety incident for your customer as well as a quality complaint. If a recall follows, the brand owner will trace the cause back through its suppliers, and a molder without documented hazard controls has little evidence to show that the fault did not start in its factory.

A certified system also reduces the checking you have to do yourself, because without it you or your customer may need to audit the molder's hygiene, pest control and foreign matter controls directly, which adds cost and time to supplier approval. With it, the certification body's audits cover much of that ground, and your own visit can concentrate on the part and the process.

Many molders in Taiwan and Southeast Asia make caps, closures and containers for export, and not all of them hold a food safety certificate. Check the scope printed on the certificate, which names the site and the products covered, since a factory may be certified for one product line and not for the molding area that would make your parts. Ask also when the last surveillance audit took place and whether any major findings remain open.

A food packaging supplier usually needs a certified food safety system, but the customer often specifies which one, and ISO 22000 on its own is not always accepted. Many food brands and retailers require a scheme recognized by the Global Food Safety Initiative (GFSI), such as FSSC 22000 or BRCGS Packaging Materials. FSSC 22000 is built on ISO 22000 with the packaging prerequisite programs and some additional requirements, so a site certified to ISO 22000 can usually move to it without starting again. Check your customer's supplier requirements before you choose a molder.
Food safety certification covers the factory's hazard controls, while food contact compliance depends on the materials and has to be shown separately. Ask for a declaration of compliance for the finished packaging, which states the regulations it meets and is supported by migration testing. Migration testing measures how much of any substance passes from the plastic into a food simulant, a test liquid that stands in for the food, under set times and temperatures. In the European Union, Regulation (EU) No 10/2011 sets an overall migration limit of 10 mg per dm² of contact surface, and in the United States the rules are in Title 21 of the Code of Federal Regulations. Colorants need the same check as the base resin, because an unapproved masterbatch, the concentrated color pellet mixed into the resin, can make a compliant resin non-compliant.
An ISO 22000 audit checks that the molder has identified the food safety hazards in its process and controls them in practice. In a molding plant, the auditor will look at how resin and regrind (reground scrap) are stored and handled, and how the molding and packing areas are protected from oil, dust and pests. The auditor will also check that operators follow hygiene rules and that finished parts are packed and traced to their production lot.